top - download
⟦1804c2837⟧ Wang Wps File
Length: 4597 (0x11f5)
Types: Wang Wps File
Notes: APPENDIX B TIL SPECTRUM
Names: »1318A «
Derivation
└─⟦0f7ba544d⟧ Bits:30006063 8" Wang WCS floppy, CR 0095A
└─ ⟦this⟧ »1318A «
WangText
- # -
A P P E N D I X B…01…---------------------------------…01……01…TECHNICAL REQUIREMENTS…01…AND…01…SPECIFICATIONS
FOR FILTERED CONNECTORS
T̲E̲C̲H̲N̲I̲C̲A̲L̲ ̲R̲E̲Q̲U̲I̲R̲E̲M̲E̲N̲T̲S̲ ̲A̲N̲D̲ ̲S̲P̲E̲C̲I̲F̲I̲C̲A̲T̲I̲O̲N̲S̲
The filtered connectors to be supplied under this contract
shall meet the specifications and requirements specified
in this appendix.
1 G̲E̲N̲E̲R̲A̲L̲ ̲S̲P̲E̲C̲I̲F̲I̲C̲A̲T̲I̲O̲N̲
2 version of filtered connectors shall be delivered.
General specifications: see figure B1.
1.1 10-PIN VERSION, PART NUMBER: 52-762-003
1.2 18-PIN VERSION, PART NUMBER: 52-762-004
2 P̲I̲N̲ ̲A̲L̲L̲O̲C̲A̲T̲I̲O̲N̲
2.1 10-PIN VERSION
The following pins shall be connected:
1, 2, 3, 5, 6, 7, 14, 16, 19, 20
Pin 1 is connected to chassis in both ends. All other
pins are connected through filters (see figure B1).
2.2 1̲8̲-̲P̲I̲N̲ ̲V̲E̲R̲S̲I̲O̲N̲
The following pins shall be connected:
1, 2, 3, 4, 5, 6, 7, 8, 12, 14, 15, 16, 17, 18, 19,
20, 24, 25.
Pin 1 is connected to chassis in both ends. All other
pins are connected through filters (See figure B1)
3 M̲E̲C̲H̲A̲N̲I̲C̲A̲L̲ ̲D̲I̲M̲E̲N̲S̲I̲O̲N̲S̲
See figure B1.
4 E̲L̲E̲C̲T̲R̲I̲C̲A̲L̲ ̲C̲H̲A̲R̲A̲C̲T̲E̲R̲I̲S̲T̲I̲C̲S̲
See figure B1.
5 E̲N̲V̲I̲R̲O̲N̲M̲E̲N̲T̲A̲L̲ ̲C̲O̲N̲D̲I̲T̲I̲O̲N̲S̲
In designing the equipment to meet the specified requirements
no account need be taken of catastrophic events such
as fire, flood, explosion, etc., which are beyond the
control of an equipment manufacturer.
The equipment will normally operate within accomodation
suitable for the operation of similar equipment produced
for commercial use.
After initial adjustments have been made, the equipment
shall maintain normal operation under all specified
environmental and power supply conditions.
a) Temperature and humidity
The equipment shall continue to function when the
humidity and temperature of its environment are
within the ranges and cycling specified below.
The equipment shall continue to operate in a fully
satisfactory manner even under the worst conditions
specified below.
a1) Temperature
Range: 10 to 50 deg. C
Change: Mac. 10 deg. C per hour
a2) Humidity (relative humidity = RH)
Range: 40 to 90 per cent RH, non-condensing
Change: Max. 6 per cent RH per hour, non condensing
a3) Altitude
Range: Sea level to 2000 meters
The equipment shall be designed in such a way
that the loss of site air conditioning or heating
will not cause a catastrophic failure within
15 minutes after the loss.
b) Dust, fumes
The equipment shall be able to operate continously
and with normal scheduled preventive maintenance
in the following air environment.
b1) Air cleaness
PARTICLE SIZE MAX ALLOWABLE NUMBER
(̲M̲I̲C̲R̲O̲N̲S̲)̲ ̲ ̲ ̲ ̲ (̲P̲A̲R̲T̲I̲C̲L̲E̲S̲/̲C̲U̲B̲I̲C̲M̲E̲T̲E̲R̲
Greater than 5 4 x (10 5)
Greater than 1.5 4 x (10 6)
Greater than 1 4 x (10 7)
b2) Fumes
Sulphur dioxide max. 14 ppm.
6 T̲R̲A̲N̲S̲M̲I̲T̲T̲E̲D̲ ̲S̲I̲G̲N̲A̲L̲S̲
The filtered connector will be used for transmission
of signals with the following main characteristics.
6.1 Standard CCITT V28 (RS 232 C) - Interface
6.2 Transmisison speed up to 10 KHz
6.3 Open Voltage is normally max. 12 Volts between lines
(pins) with load connected. With disconnected load
max. 50 volts between lines (pins).
FIGURE B1
A P P E N D I X D…01…-----------------------------…01……01…TEST PROCEDURES
T̲E̲S̲T̲ ̲P̲R̲O̲C̲E̲D̲U̲R̲E̲S̲
D1 SC shall submit to CR for their review and approval
the test procedures to be used during the First Article
Test at least 30 days prior to the First Article Test.
The first article test shall verify that the filtered
connectors meet the requirements of this contract.
D2 CR shall have the right to be present during the First
Article Test.
D3 SC shall deliver to CR the First Article Test Report
immediately after the test.
D4 SC shall deliver to CR the test procedure to be used
for the Factory acceptance test and a description of
the test set-up including recommended instruments etc.
