DataMuseum.dk

top - download

    Length: 4120 (0x1018)
    Types: TextFile
    Notes: @(#)ioc.msg 13.1 (RC International) 91/02/02 */
    Names: »IOC.err«

└─⟦50656ff4a⟧ Bits:30010538 TX 3.1 Coldstart
    └─⟦a83e7cf70⟧ »0003« 
        └─⟦this⟧ »./etc/logerr/IOC.err« 
└─⟦50656ff4a⟧ Bits:30010538 TX 3.1 Coldstart
    └─⟦bbf173f5c⟧ »0004« 
        └─⟦this⟧ »./etc/logerr/IOC.err« 

TextFile

/* @(#)ioc.msg	13.1 (RC International) 91/02/02 */

subsys ioc 80
/* This file contains log messages for all IOC's in RC9000-TX */
/* systems (IPI & SCSI)                                       */

info    c_no_error          "I/O %d%d0 : No error"
/* No error. Should never be reported in log */

severe  c_ipi_not_idle      "I/O %d%d0 : Channel not idle"
/* The I/O channel is not idle after a deselect */
/* The controller is not responding corretly on */
/* a level I sequence                           */

severe  c_no_release        "I/O %d%d0 : Will not release"

warn    c_reset_error       "I/O %d%d0 : Reset error"
/* Controller is not ready after a logical interface */
/* reset, but has set the attention bit              */

warn    c_rec_res_error     "I/O %d%d0 : Receive response error"
/* The response packet from the controller can not */
/* be received without error                       */

warn    c_rec_data_error    "I/O %d%d0 : Receive data error"
/* Data from controller can not be received without error */

warn    c_send_data_error   "I/O %d%d0 : Send data error"
/* Data to the controller can not be send without error */

warn    c_trans_error       "I/O %d%d0 : Transfer error"
/* A transfer notification to a unknown or non i/o */
/* command is received                             */

warn    c_resp_error        "I/O %d%d0 : Response error"
/* A unrecognized response type is received fron the controller */

warn    c_bus_error         "I/O %d%d0 : Level I Bus error"
/* The IOC gets IPI level I bus control errors on sending */
/* command to controller, the controller is not OK */

severe  c_fifo_error        "I/O %d%d0 : IOC FIFO error"
/* The internal IOC FIFO is in error */

warn    c_slave_octet       "I/O %d%d0 : Slave-octet error"
/* Error in slave-octet (slave status) when sending command */

info    c_send_com_error    "I/O %d%d0 : Send command retry"
/* The IOC retries to send a command to controller */

warn    c_busy_error        "I/O %d%d0 : Controller busy error"
/* The controller is busy more then 4 sec. after logical */
/* interface reset.                                      */

warn    c_ill_trans         "I/O %d%d0 : Illegal transfer notification"
/* A transfer notification is received to a already answered */
/* command. The command must have been aborted without the controller */
/* online. The illegal response is skipped.                           */

warn    c_ill_answ          "I/O %d%d0 : Illegal answer packet"
/* A answer to an already answered command is received. */
/* The command must have been aborted without the controller */
/* online. The illegal response is skipped.                  */

warn    c_not_ready         "I/O %d%d0 : Controller not ready after reset"
/* The controller could not be reset */

warn    c_already_ans       "I/O %d%d0 : Command already answered"
/* A answer to an already answered command is received. */
/* The command must have been aborted without the controller */
/* online. The illegal response is skipped.                  */

warn    c_in_use            "I/O %d%d0 : Buffer already in use"
/* A internal command buffer is alrady in use. */
/* This is normaly because the ioc online monitor is used */

warn    c_ill_length        "I/O %d%d0 : Illegal packet length"
/* A response is received with a illegal packet length. */
/* If the controller sets the attention bit without */
/* setting a response in the fifo this will happend */

warn    c_disabled          "I/O %d%d0 : Controller disabled"
/* The controller has been disabled by the IOC. */
/* The IOC will disable a controller if it is 'haning up' */
/* the channel. This can happen because of a HW error */
/* on the controller channel interface or because of error in the */
/* controller SW (the SW has stopped without resetting)   */


info    c_msg_info          "I/O %d%d0 : %s"
/* For general use */

warn    c_msg_warn          "I/O %d%d0 : %s"
/* For general use */

severe  c_msg_severe        "I/O %d%d0 : %s"
/* For general use */

fatal   c_fatal             "Fatal error on IOC %d; status = %d"
/* Fatal error on the IOC */