DataMuseum.dk

top - download

    Length: 1571 (0x623)
    Types: TextFile
    Notes: @(#)Help 13.2 (RC International) 91/08/23
    Names: »Help«

└─⟦50656ff4a⟧ Bits:30010538 TX 3.1 Coldstart
    └─⟦bbf173f5c⟧ »0004« 
        └─⟦this⟧ »./usr/sadm/sysadm/add-ons/lp/printers/printers/add/Help« 

TextFile

#	@(#)Help	13.2 (RC International) 91/08/23

ABSTRACT:

add:F1:Local Printer Name
	Enter the local name of the printer. Names must contain
	max. 14 characters (letters, digits and '_'). The names
	'all', 'any' and 'none' cannot be used since they are
	reserved. Also, you cannot use a name that has already
	been used.

add:F2:Device Identification
	Enter the name of the device node (/dev/...) to which
	this printer is physically connected. This device node
	must already exist (ref.: Site Management Guide,
	chapter 15: System Customization). Valid selections
	are shown if you press CHOICES.

add:F3:Interface Program
	Enter the name of an existing model program (press CHOICES
	to see valid selections). All print requests are routed
	through the interface program which you may modify to
	fulfil special needs. It it located in the following
	directory: /usr/spool/lp/interface and has the same name
	as the name you choose as the local printer name.

add:FTS:F1:Local Printer Name
	Enter the local name of the printer. Names must contain
	max. 14 characters (letters, digits and '_'). The names
	'all', 'any' and 'none' cannot be used since they are
	reserved. Also, you cannot use a name that has already
	been used.

add:FTS:F2:Remote Host name
	Enter the name of the remote host on which the printer
	is physically attached. You can see valid selections by
	pressing CHOICES.

add:FTS:F3:Remote Printer Name
	Enter 'lp' if you want to use the default FTS printer on
	the remote host. You may also enter the name of a printer
	that are known on the remote host.