DataMuseum.dk

top - download

    Length: 7397 (0x1ce5)
    Types: ERRMESS, TextFile
    Names: »IOP_PANICS.ERRMESS«

└─⟦24d56d853⟧ Bits:30000744 8mm tape, Rational 1000, DFS, D_12_6_5 SEQ293
    └─ ⟦this⟧ »IOP_PANICS.ERRMESS« 
└─⟦9031b0687⟧ Bits:30000407 8mm tape, Rational 1000, DFS, D_12_7_3
    └─ ⟦this⟧ »IOP_PANICS.ERRMESS« 

TextFile

9999	--These codes are defined in CRASH_DEFS
0	AC power low was detected but DC power remained OK
1	I/O Processor odd address or bus error
2	Odd DFS space address specified for read/write diagnostic area
3	DH11 driver transmission failed, non-existent memory
4	Device bus request test failed to get a device interrupt
5	Disk controller bus request level is incorrect
6	RH11 driver request to non-existent disk drive
7	I/O request to null device
8	I/O Processor Kernel ran out of heap space
9	I/O Adaptor driver send status packet command is unimplemented
10	I/O Adaptor driver could not find a buffer to allocate
11	Tape controller bus request level is incorrect
12	Communications controller bus request level is incorrect
13	I/O Adaptor NEW_STATUS interrupt received but not supported
14	SLU bus request level is incorrect
15	SL-121 EEPROM read failed
16	Diagnostic modem protocol error, connect packet received
17	DH11 controller is jumpered for the wrong number of distribution panels
18	DFS kernel call after operations disabled
19	DFS kernel call left trash on kernel stack
20	DFS Fatal error (DFS made a KC_CRASH kernel call) 
21	DFS called CHAIN with non-disk boot device
22	Disk error during DFS CHAIN
23	SL-121 EEPROM write failed
24	Ethernet driver timer fired without having a configuration request
25	Ethernet driver interrupt handler got an unexpected command completion
26	Ethernet SORECEIVE completed with no associated rcb
27	Ethernet SOSEND completed from I/O Adaptor with no associated rcb
28	Ethernet Response Message overflow condition
29	UDP channel of Ethernet Driver blocked on SOSEND
30	VMEGEN failed selftest
31	Disk request unexpected
32	I/O Adaptor XMIT_ERROR
33	I/O Adaptor STATUS_SENT interrupt received but not supported
34	X25 request unexpected
35	I/O Adaptor IO_ERR on buffer state command
36	Illegal DH11 driver output page command
37	DH11 driver output page command to unit #0, line #0
38	Invalid TAPE SUBSYSTEM CONFIGURATION detected 
	Set the front panel key to INTERACTIVE mode then re-configure the IOP.
39	I/O Processor Kernel constraint check failed
40	Interrupt occurred through an unassigned vector 
41	I/O Processor RESERVED INSTRUCTION trap  
42	I/O Processor BREAKPOINT/TRACE trap
43	I/O Processor MAP or ATU parity error
44	DFS called DISALLOW_SOME_OPS with unprocessed packet(s) 
45	Spare 45
46	Spare 46
47	Spare 47
48	Spare 48
49	Spare 49
50	I/O Adaptor NEWEMPTY interrupt received but not supported
51	DH11 driver output request to non-existent unit
52	Spare 52
53	Spare 53
54	Spare 54
55	Cluster Manager did not check in
56	RH11 driver detected inconsistency in attention conditions
57	RH11 driver received unknown transfer completion interrupt
58	RH11 driver received completion interrupt with drive not ready
59	RH11 driver drive clear failed
60	I/O Processor REQUEST MANAGER received duplicate command id
61	Cluster Manager 8031 initiated crash
62	RH11 driver recalibrate failed
63	DH11 driver received read character request for non-existent unit
64	Spare 64
65	Spare 65
66	RH11 driver received attention interrupt with unknown cause
67	RH11 driver pack acknowledge failed
68	Spare 68
69	DH11 driver output command to unassigned line on unit 0
70	DFS output command to unassigned line on unit 0
71	Spare 71
72	Spare 72
73	I/O Processor IOT instruction trap
74	I/O Processor memory management trap  
75	Attempt to exceed maximum queue length
76	X25 driver received a command for an active line
77	X25 driver received a completion from an inactive channel
78	X25 driver received a write data packet when in the wrong state
79	Spare 79
80	X25 driver received incomplete write data for the wrong channel
81	Spare 81
82	DFS left diagnostic mode without initializing the sysbus
83	DFS attempt to use uninitialized sysbus
84	Recursive 68000 bus error
85	Couldn not find the timer that went off for the X.25 driver
86	Non-memory parity error trap through 114
87	I/O Processor memory parity error
88	I/O Processor Kernel stack limit violation
89	DFS called chain to program with outstanding I/O
90	DFS attempted to start I/O on an active channel
91	Spare 91
92	I/O Adaptor hardware malfunction during I/O read operation
93	Illegal buffer state encountered during an I/O operation
94	Target buffer for incoming data pkt is not in RCV state
95	Target buffer for incoming status pkt not in UNACK state
96	Successfully transmitted buffer not in XMIT, XMIT_WAIT or STAT state
97	Unsuccssfully transmitted buffer not in XMIT, XMIT_WAIT, or STAT state
98	I/O Adaptor BS encoding 6 is not presently assigned but occurred
99	Illegal buffer state encountered by hunters
100	I/O Adaptor error or inconsistent bus state
101	I/O Adaptor error or inconsistent bus state
102	Multiple senders during SYSBUS transmission
103	Nested I/O Adaptor IPC error
104	Unexpected loss of busy while receiving
105	I/O Adaptor IPC bid lockout
106	I/O Adaptor IPC incorrect abort
107	IPC SB encoding 7 is not presently assigned but occurred
108	I/O Adaptor IPC error interrupt with no error bit set
109	Unimplemented X25 command request
110	Checking on or waiting for I/O on unused RCB
111	Unexpected diagnostic modem interrupt
112	Diagnostic communications error
113	Diagnostic communications receive interrupt while transmitting
114	Packet ID in request doesn't match packet ID in packet header
115	Error in request which requires multi-part response
116	Attempted to respond to request which wasn't in use
117	Encountered last packet in request before data count exhausted
118	Spare 118
119	DH11 communications controller exists but multiplexer panel doesn't
120	Multiplexer panel exists but DH11 communications controller doesn't
121	Communications mux addressed nonexistent memory
122	Communications mux BCR out of range
123	One or more 68000 registers changed in an interrupt handler
124	Spare 124
125	Spare 125
126	Spare 126
127	Spare 127
128	Server crash
129	Spare 129
130	TX ring entry not available during link initialization
131	HAWK ram parity error detected
132	TX/RX Ring ownership not as expected
133	Unrecoverable LANCE error
134	HAWK software check detected
135	LANCE RMD_0 error
136	A fragmented IP packet was encountered and re-assembly not yet supported.
137	LANCE TMD_0 error.
138	A DFS multi_part disk request was received.
139	A DFS multi_part_response disk request was received.
140	A DATAGRAM was received and the UDP length indicates more than a page of
	data.
141	Maximum number of unacknowledged retransmissions of a packet has been
	exceeded.
142	Logical tape unit not a valid index into perm_state.tape_map.
143	There is no DCB associated with the Tape unit that just interrupted.
144	There is no active request for the Tape unit that just interrupted.
145	Counter expired while waitng for Tape SCSI to signal interrupt.
146	Attempt to reset Tape SCSI failed.
147	Attempt to communicate with Tape controller failed.
148	Tape device status other than "GOOD" or "CHECK_CONDITION" encountered.
149	Tape SCSI returned inappropriate "PAUSED" status.
150	Tape SCSI returned inappropriate "SERVICE REQUIRED" status.
151	Tape SCSI unexpectedly returned "RESET" status.
152	Test-unit-ready did not complete successfully.
153	Invalid unit number in SPCB.CDB registers: something clobbered Tape SCSI
154	Invalid Tape map: two devices map to same unit.
155	RCB's command code out of table limits.
255	IOP reboot requested before I/O Processor had finished booting