DataMuseum.dk

Presents historical artifacts from the history of:

Rational R1000/400 Tapes

This is an automatic "excavation" of a thematic subset of
artifacts from Datamuseum.dk's BitArchive.

See our Wiki for more about Rational R1000/400 Tapes

Excavated with: AutoArchaeologist - Free & Open Source Software. 

top - metrics - download
Index: R T

⟦f6c9ffdd8⟧ TextFile

    Length: 1332 (0x534)
    Types: TextFile
    Names: »RULES_FOR_RATIONAL_DIALOGUE«

Derivation

└─⟦180fe333a⟧ Bits:30000405 8mm tape, Rational 1000, SW CATALOG, 10_20_0
└─⟦180fe333a⟧ Bits:30000537 8mm tape, Rational 1000, SW Catalog 10_20_0
    └─⟦5cb1d1d7f⟧ »DATA« 
        └─⟦3b1ee7bd8⟧ 
            └─⟦this⟧

TextFile


                 
                        WELCOME APOLLO ==> RATIONAL USER

     Read the directions in this file to complete logon to Rational.
     When logon is complete press the "POP" key with the cursor in 
     this window to reveal the Rational keyboard map for this keyboard.
     Pressing "POP" again with the cursor in this window will reveal
     this message.


  1.    The large window on the left should be displaying two lines --
        ' Trying...   
          Open     '  
        a)  Place the cursor in the left window.
        b)  Press  <RET>  at this point.
            (If  '(telnet) Cannot connect'  appears press "CTRL Z" to end
             this procedure and then try again.) 
  2.    At the  'Enter Username:'  prompt --
        a)  Type  "="  <RET>
  3.    At the  'Enter Terminal Type (______):'  prompt --
        a)  Type  "Apollo"  <RET>
  4.    At the following prompts fill in the appropriate parameters.
        a)  'Enter Username:'  Your username.
        b)  'Enter Password:'  Your password.
        c)  'Enter Session:'   <RET> or a special session if you have one.
  5.    Logon should proceed.  When you have promoted "Quit" in a Rational
        command window you will logoff the system and these four windows
        will disappear, returning the Apollo to the state it had been in.